威尼人斯网址

Hello, welcome to Zhejiang Jie Li Da HVAC Technology Co., Ltd. official website!

Popular science column

You are here:Home > Popular science column

[To warm the water separator] check, warm winter y

  • [To warm the water separator] check, warm winter y
  • 2017-02-23 19:02:43
  • After the completion of the installation of warm, in the latter part of the use of the same process there are many considerations, only the correct use and maintenance, in order to make the warm to maintain a good use of state and extend the service life.

    1, to warm the pipe cleaning problem
    Usually plumbing in the use of 3-5 years after the need to do a cleaning, especially the central heating to warm the user, because the main channel is not pure water in the cycle, so there will be impurities attached to the warm wall, the scale of the possibility of a long time It will affect the indoor heating effect, then it is necessary to warm the ground to do a cleaning.

    2, to warm the water separator valve cleaning
    At the beginning of the annual heating period, it is recommended to clean the water separator and the above filters and valves to ensure that the water pipes are cleaned and prevent the piping from clogging. Clean the method: first close the inlet and outlet valves connected to the main pipe and then open the filter Equipment, remove the filter and clean, check the warm water separator filter with or without damage, plug, if damaged should be replaced with the same specifications of the filter, to be checked without problems after the original method to install back.

      3, control the water temperature
    Floor heating is a low-temperature operation, whether it is central heating or household heating system to be warm to the water temperature control within 60 ℃, the water temperature is too high to the impact of the life of the heating pipe, the water temperature is too low may not meet the heating needs, Every winter in the opening to warm the system, we must strictly in accordance with the provisions of the heating process cycle, can not step up in place.
    4, on the drainage
    When the home long-term uninhabited, indoor below 5 ℃, it is recommended to warm the water in the pipeline to prevent the pipeline caused by unnecessary losses caused by freezing.

     5, security protection
    Whether it is the second renovation or is being used to warm the user, in daily life should pay attention to prohibit smashing, knock on the ground, is strictly prohibited in the ground wedge any sharp objects to prevent damage to underground pipes. Only to maintain a good use and maintenance habits, in order to make your warm and more efficient and energy efficient, so you enjoy a more warm winter.

    Related Products Recommended: Zhuji water separator /index.php?s=/products.html

[Chinese life] - Zhuji water separator

  • [Chinese life] - Zhuji water separator
  • 2017-02-23 19:02:44
  •  From the functional and structural point of view, sub-catchment (Zhuji water separator) is divided into three types: basic, standard and functional.
        1, the basic type: by the water mains and water mains. A ball valve is provided at each branch port of the branch water main pipe, and a manual exhaust valve is provided on the branch water main pipe. The basic type of water separator does not have the flow regulation function.
        2, the standard type: standard sub-catchment (Zhuji water separator) structure with the basic type of the same, but the stem on the ball valve by the flow control valve instead. The manual exhaust valve on the two main pipes is replaced by an automatic exhaust valve. Standard sub-sumps can adjust the flow rate of each loop, and even the flow of luxury standard sub-sump can be adjusted to achieve artificial intelligence.
        3, functional type: functional sub-collector in addition to all the features of the standard sub-catchment, but also has a temperature, pressure display, automatic flow adjustment function, automatic mixing water heat function, thermal metering function, indoor partition temperature Automatic control function, wireless and remote control function.

      In order to prevent corrosion, sub-catchers are generally made of corrosion-resistant metal or synthetic materials. Commonly used materials are copper, stainless steel, copper nickel, alloy nickel, high temperature plastic and so on. Sub-sump (including connectors, etc.) should be smooth inside and outside the surface, no cracks, trachoma, cold separation, slag, uneven uneven defects, surface plating of the connection, the color should be uniform, the coating is firm, defect.

    Water separator manufacturers /index.php?s=/aboutus.html

     

     

Zhejiang water separator, walk in the forefront of

  • Zhejiang water separator, walk in the forefront of
  • 2017-02-23 18:02:58
  • Economical forging one ball valve sub water collector

    Forging one sub-collector (Zhejiang water separator) Basic information:
    ● 1 inch boutique one forging process;
    ● product as a whole to 1 to 8, 9 or more can be any splicing;
    ● Nominal pressure: PN10;
    ● pipe fittings with direct outlet;
    ● 59-1 brass precision forging, can be divided into copper color and nickel two;
    ● suitable for water or concentration of not more than 60% of ethylene glycol;
    ● the manager and the branch pipe seamlessly, completely "drain";
    ● Main bar high temperature tempering and color processing.

    Related Recommendation: Paraffin Actuator /contact


[To warm the water] excellent contribution from yo

  • [To warm the water] excellent contribution from yo
  • 2017-02-23 19:02:46
  • Water separator (to warm water separator) is not it very important? We think it is very important, it into the heating system plays a very important role. If the boiler is compared to the car's engine, then the water separator is the car's gearbox: if the warm pipe to the human blood vessel network, then the water is the central nervous system. Boiler only a "heat source" fills, even a "coal stove", only a good match, but also a good play, not to mention the current domestic market, home boilers are almost all world class. Character is very good, warm to run very reliable: pipe products are also very mature, the vast majority of domestic pipe products can be very good to meet the independent heating to use the system, without too much worry. And the real operation of the system plays a very important role in the water separator has been ignored, it is very deformed, nor should it. Not only the most "expensive" water separator talent to meet.

        Set of water (to warm water separator) applications, in order to create a high, intelligent floor heating system. But to decide whether to meet the functional needs, to warm the water separator may be balanced, with the manipulation of intelligent control, is conducive to energy conservation, and quality of the protection of the water separator products. So we need a careful analysis, thorough understanding, fair selection, making us "to warm the system" optimization. Really make "warm" to become a kind of insurance, reliable, comfortable, energy saving, environmental protection, high-level ancient residential lifestyle facilities, making "warm" to become professional, honest and respected industry.

    Related Recommended: stainless steel sub-catchment /news/index/p/2/message/message/message/message/message/message/message/guide


High-quality To warm the water separator products

  • High-quality To warm the water separator products
  • 2017-02-23 19:02:46
  • In the installation of warm (to warm the water separator), many users will worry about a problem, to warm the tube buried in the floor below, if there is leakage of the problem how to solve, how to believe that we all thought, but I can certainly tell you , A good installation team with high-quality geothermal water heater heating products is not the problem of water leakage.

        In the winter, the use rate is very high, is the user used as a low temperature hot water circulation flow carrier of a pipe. To warm the tube high temperature, anti-ultraviolet strong, but also both high temperature characteristics, the use of a long time, pipe toughness is relatively strong, do not need to consider the installation of the climate caused by damage. Is the majority of home users preferred pipe.

    To distinguish the quality of good pipe, to buy the warm tube when the need to pay attention to personally go to the scene material, first look at the surface of the pipe should not be rough, there are rugged feeling, to be flat, no color, and impurities, and then touch A good quality tube is delicate, smooth, pinch, and toughness, will not easily damage.

    Other products recommended: water separator experts /products/dir/claid/116.html


39 条记录 5/8 页 上一页 下一页 1234 5 >> 末页

Home  |  Jie Lida water separator  | about us  |  Products  |  Download  |  Careers  |  Technical Support  |  contact us

浙ICP备10003325号 Zhejiang Jie Lida Pipe Industry Co., Ltd Contact: Li Yunhai mobile number:13606852630 phone:0575-87669088 fax:0575-87669008

Address: Zhejiang Province Zhuji City shop town Yang Yan Road Zip code:311835   Backstage management

XML 地图 | Sitemap 地图